This saves materials with respect to construction.The blocks are made of high-quality injected nylon and replace the plastic support strips metal longitudinal strips will suffice.No weld, a locking screw is placed into the block.This product has several functions, which among other things improve the modular qualities of the eyelink belt (no welds), and generally also the hygiene. Plastic blocks are a patented item of Twentebelt. The plates actually function as a “buffer” between the welding heads and the guidance or other constructions the sides of the belt can get in touch with. Guide plates serve as a protection for the welding heads. The selection of the chains depends on the operating conditions. For this purpose only hollow pin roller chains are used with pitch measurement equal to those of the belt. This results in a thorough finishing of the belt in combination with the desired bearing surface.Įyelink conveyor belts are usually fitted with chains, if the belt is to perform a negative bend. Twentebelt offers 4 different side finishes for its eyelink conveyor belts.Īt both sides the belt is fitted with plate links, and the far ends of the cross rods are fitted with washers and subsequently welded. When bushings or washers are added the belts become heavier and more rigid. This is important in situations when the conveyor belt is loaded manually and/or laterally.īushings or washers are meant to create an opening between the eyelinks. The result is a relatively light belt with specific qualities, such as a good shock resistance and resistance to lateral forces. The placement of springs between the eyelinks ensures that they are positioned at regular intervals. The modular structure makes the assembly of very broad belts possible. The accuracy of our welding process allows us to produce modules with very small intervals between the eyelinks. Some applications require a stable belt in combination with a small opening/drain. The minimal opening is equal to the eyelink diameter + 0,05mm. Modular eyelink conveyor belts are stable, also in dimensional respect. Its only function is related to the dimensions of the product (the desired drain). The use of more than one location wire will not make the belt more solid. The standard method is the use of one location wire. The eyelinks can be set according European or American assembly, depending on the requirements of hygiene. Very narrow and very wide openings can be created, depending on the processing of the products concerned. The eyelinks are welded on to an location wire, so that a module is created. This method is very appropriate for small and fine-structured products. By flattening the eyes of the eyelinks the opening between the links becomes smaller. Some applications require the smallest opening possible. This method can best be used for products likely to fall, or for applications that require small openings.
#HOY EYECONNECT FULL#
On a full eyelink belt the eyelinks lie against each other, and the opening is equal to the wire diameter. The basic principle of all eyelink conveyor belts versions. Twentebelt offers a variety of eyelink belts.
0 kommentar(er)
